Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Formulas-based Payroll Category is calculating way too low

 

 

...

Problem:

A formula-based payroll category has been setup as (for example) 10% of salary, but is only calculating at 1% - way too low.

Cause: 

 

Solution

 

This Typically, this is because the percentage has been duplicated, and the formula is calculating at 10% of 10%. Here is why

Solution:

 

There are two ways to setup a formula percentage in PaymateAcclaim: 1)

  1. You can setup a percentage that will apply for ALL employees

...

  1. Each employee will have a different percentage (i.e. some employees have 10%, some are at 8%).

...

 


Since the system carries the percentage for the category in two places, the percentages will be duplicated if entered in both areas. You must set up these categories as follows:

 

If the percentage is the SAME for all employees:

  • The percentage should be input at the proper rate in the Payroll Category setup, and then input as 100% in the employee’s setup.
  • This

...

  • will calculate the employee as 100% of the 10% being calculated by the formula.

...

 

...

If the percentage is DIFFERENT for all employees:

The percentage should be input at 100% in the Payroll Category setup, and then input as the proper percentage in the employee’s setup (i.e. 10%). This, then, will calculate the employee as 10% of the 100% being calculated by the formula.

...